How to modify an automatically generated schematic view

Problem description

After the automatic generating of a schematic view of the installation in some cases its modification is required.

Use Control point to:

Change the Direction - Possibility to change the location of the installation on the schematic view (right / left), starting from the node behind which the Control point was inserted.
Disconnect on schematic view - Possibility of correction the route of the schematic view. Control of order of presentation the parts of the installation on the schematic view:
"Yes" - during generation, the part of the installation is disconnected from the node (Tee/crosspiece) behind which the Control point is inserted
"No" - the part of the installation starting from the node behind which the Control point is inserted is not disconnected from the leading route.
Modify the Order of installation fragments - Order of installation fragments - Entering a number determines the order in which parts of the installation supplied from manifold individual outlet ports will be developed.
Note: to specify the fragment of the installation to be generated use the Starting point and the Endpoint.
Reduce gaps in the pipeline sections.

To modify the elevation of the pipe-runs use the functions: