Sewage installations - Bypass ventilation: Difference between revisions

Revision as of 16:09, 21 June 2023

The article describes methods of implementation of double stacks, which are a combination of sewage and ventilation bypass stacks.

The type of the stack is indicated in the Data table.

Following points should be specified:

Automatic creation of parallel ventilation;
Element on top of the vent stack;
Elevation of upper point of connection of ventilation stack to drainage stack;
Elevation of lower conn. of vent stack to drain stack;
Generate intermediate ventilation connections.

The program provides several ways to perform such types of stacks.

Schema A:
- Parallel ventilation stack is connected to the sewage stack at the bottom near the stack foot and at the top to the vent cowl;
- Generate intermediate ventilation connections can be made or not depending on the project features. In the presented example, this type of connection is made.

Optional section that contains additional information describing the function/element of the program..

@@ Line 37: / Line 37: @@
 The program provides several ways to perform such types of stacks.
 * Schema A:
-** Parallel ventilation stack is connected to the sewage stack at the bottom near the stack foot and at the top to the vent cowl.
+** Parallel ventilation stack is connected to the sewage stack at the bottom near the stack foot and at the top to the vent cowl;
 ** ''<IS_TS id=LacznikiNaKazdejKondygnacji/>'' can be made or not depending on the project features. In the presented example, this type of connection is made.