How to eliminate: "Insufficient number of manufacturer's products"

From HelpSystem
Jump to navigation Jump to search


Product InstalSystem 5
Type of article TIP&TRICK
Source for translation 2024-12-17


Problem despcription

After calculating the heating, cooling or water supply system installations, an error message appears in the Diagnostics window:

INSUFFICIENT NUMBER OF MANUFACTURER'S PRODUCTS - Check requirements in "Catalogues" section

The above message in the software, in the manufacturer's version, reports that the condition of using a certain number of products from the catalogues listed - along with the percentage of participation - on the Catalogues under the Screenshot 2024-10-30 151728.png icon next to the table title Catalogues in project:, has not been fulfilled.

The quantity is verified for each installation of a given scope that has a separate source.

1. Catalogues in project - required quantities of use.


Note: The restriction on the use of catalogues may be different for each project scope. For the project scope Water supply systems in the valve manufacturers' software versions there is a requirement to use only pipes from the neutral catalogues indicated in the software. In contrast, in the same software for the project scopes: Heating systems and Cooling systems this requirement does not apply.

Solution

On the Types and default data or in the Data table window, in the Pipe type boxes, select products from the catalogues with minimum required quantity of use, so that their required percentage is fulfilled. The software verifies the length as well as the number of pipe-runs used from the specified manufacturer's catalogue..

Keep in mind that the required number of products is checked for each source, and each Project scope may have a different set of required catalogues.


For more information, see: Using catalogues and catalogues data in the project.