Appending drawings with radiant system loops

说明

可以在Heating-cooling surface部件(地面和天花板)上添加盘管图，程序自动绘制的盘管图在项目每次重新计算时都会更新。盘管图可修改或重新绘制，也可手动绘制盘管图。建议在设计的最后阶段再进行手动编辑，以美化回路图。

General data - 对Generate loops drawings前的复选框进行勾选，可以对所有部件开启自动绘制盘管图功能。
1. 盘管图 - 一般参数
当在 Rad.-floors,walls/Rad.-ceilings 层进行编辑时，对于Heating/Cooling Floor Zone部件, 打开Data table，通过选择Generate loops drawings复选框，可启用自动绘制盘管图 ; 对于一选定的部件，在General data前选择其复选框, 也可取消自动绘制盘管图。
- 盘管方式的选择.
  2. 盘管方式

在Main tools工具条中有RHC loop工具, 当在Loop drawings-floor/Loop drawings-ceiling 层编辑时, 可手动绘制盘管图。使用这个工具时，建议开启GRID 模式.

在基本参数中或对所选择的部件开启自动绘制盘管图。
对所选择的部件选择与省缺盘管方式不一样的其它盘管方式。
选择Loop drawings-floor/Loop drawings-ceiling编辑区.
指出每一回路管材的盘管方向. 这可通过盘管方向指示器 来完成，它将在选择了Heating-cooling surface之后出现. 如果为Spiral pipe pattern, 就会出现盘管方向指示器。若想改变盘管方向，按住指示器上的LMB并带着紫色箭头拖动到所需的盘管开始方向。如果为Single pipe meander pattern/Double pipe meander pattern, 就会出现两个指示器: 可选择改变盘管开始方向以及选择平行于平行型方向布置的边 .
重新计算项目 . 在重新计算后，盘管图就会自动生成.
如果需要，可通过重新定位盘管指示器以改变盘管方向并再次计算，就可更新盘管图。

Disable generation of loop drawings for selected components Heating-cooling surface.
Attention! Clearing the Generate loops drawings option does not remove existing drawings of loops, it only freezes them in their current state and enables manual editing or deleting thereof.
Enable the GRID mode which helps in correcting or manual drawing of loops. Grid nodes are arranged at the minimum distance allowable for the selected pipe laying pattern. Colours of grid nodes are repeated for the current pipe spacing, which facilitates drawing with the use of that spacing. The grid can be arranged parallel to selected edge of component Heating/Cooling Floor Zone by positioning on that edge the blue hot-point . It becomes available when component Heating/Cooling Floor Zone is selected.
Correct/draw manually selected segments of loop.

Graphic style - in order to improve the legibility of loop printouts, one can:

use component appearance style where zones of heating/cooling surfaces are transparent,
disable structure display or remove base drawing,
select manner of loop display where loops differ in colour and pipe feeds are of the same colour as the corresponding loops

Diagnostics - when the program is not able to generate a loop drawing for a given component, a warning is displayed in the diagnostics window. To rectify this, either the pipe laying parameters have to be adjusted or the Generate loops drawings checkbox must be cleared and the drawing modified manually. Manual modification may also be applied when the automatically generated drawing does not satisfy the user's expectations.